0,5 Liter Carbon Bottle 300 BarSpecs: Water capacity: 0,5 LiterOuter diameter: 61,5mmLength: 300mmWeiht: 0,6kgColor: blackWorking Pressure: 300barTest Pressure: 450barMade to: EN12245

03b3-mm01 Hill Quickfill connection for cylinder type DIN 200/300 Enables the connection of a DIN 200/300 bar cartridge to the compressor hose with a standard best fitting or foster compatible quick lock. Perfect to fill cartridges with the EC-3000 compressor.

1,1 Liter Carbon Bottle 300 BarSpecs: Water capacity: 1,1 LiterOuter diameter: 86,5mmLength: 311mmWeiht: 1,06kgColor: blackWorking Pressure: 300barTest Pressure: 450barMade to: EN12245

02b3-ml01 1/8 "BSP Quickfill coupling, male, including sealing the quickfill coupling can be used between a compressed air tube and a filling piece for screwing. to be closed.

06R01010 Hill 1/8 "sealing ring slice for sealing screw connections of the compressed air Accessories.

3,0 Liter Carbon Bottle 300 BarSpecs: Water capacity: 3,0 LiterDiameter: 114mmLength: 454mmWeiht: 2,2kgColor: blackWorking Pressure: 300barTest Pressure: 450barMade to: EN12245

This service kit is designed to be used after your EC-3000 Compressor reaches 100 hours of run time.The kit has everything you need to service your compressor after 100 hours of run time use and includes:1 x 15g Tube of Hill Silicone Grease1 x 50ml Hill Crank Oil1 x 100ml Hill Silicone Oil1 x Inlet Filter2 x Burst Disk5 x Bonded Seal1 x Stage 3 Piston Seal1 x Guide Ring1 x Shim Valve1 x Stage 3 Bullet Valve1 x Bleed Screw Seal1 x 1st Stage Piston Seal1 x 2nd Stage Piston Seal1 x Piston Shaft Seal1 x Final Stage Gasket2 x Spring Valves2 x Peak shuttle valve1 x Valve tool1 x Shim valve box1 x 15g Tube of Hill Silicone Grease1 x 50ml Hill Crank Oil1 x 100ml Hill Silicone Oil1 x Inlet Filter2 x Burst Disk1 x Bonded Seal1 x Stage 3 Piston Seal1 x Guide Ring1 x Shim Valve1 x Stage 3 Piston Backup Ring1 x Bleed Screw Seal2 x Shuttle valve1 x Valve tool1 x Shim valve box

This service kit is designed to be used after your EC-3000 Compressor reaches 50 hours of run time.The kit has everything you need to service your compressor after 50 hours of run time use and includes:1 x 15g Tube of Hill Silicone Grease1 x 50ml Hill Crank Oil1 x 100ml Hill Silicone Oil1 x Inlet Filter2 x Burst Disk1 x Bonded Seal1 x Stage 3 Piston Seal1 x Guide Ring1 x Shim Valve1 x Stage 3 Piston Backup Ring1 x Bleed Screw Seal2 x Shuttle valve1 x Valve tool1 x Shim valve box

9,0 Liter Carbon Bottle 300 BarSpecs: Water capacity: 9,0 LiterDiameter: 174mmLength: 575mmWeight: 5,2kgColor: blackWorking Pressure: 300barTest Pressure: 450barMade to: EN12245

04B3-D110 Best Fittings Charging Kit with 100 cm hose 100cm Ultima hose. Braided high-pressure gas microphy made of stainless steel with 1/8 ″ BSP interior thread and end screws made of solid stainless steel.

Best fittings Fast coupling adapter 02B3-FM01

Dieser Adapter ist passend für Aluminium- oder Carbon-Flaschen mit einem M18x1,5" Gewinde.

Manufacturer article number: 08B2-AC01 Durable belt to wear bottles with a comfortable, shaped rubber grist. Makes wearing heavy bottles a pleasure! The universal, adjustable belts fit for most bottles of 3 to 15 liters.

02B3-FM04 Best Fittings Quickfill Adapter Foster Female Langunser new adapter was developed to enable the connection to "Foster" filling stutz that are entered deep in the shaft. If you need a unlocking tool for the clutch, this socket should solve this problem because the unlocking ring is a full 30 mm long, in contrast to the 10.5mm long on our standard coupling.

Crank Oil 50ml bottle engine oil engine oil for the Hill EC-3000 compressor. Please never operate the compressor without oil! More information on this in the operating instructions of the compressor.

Z2128-300 Hill DIN 200 adapter, female adapter to fill a compressed air cartridge with 5/8 “thread on a 1/8” hose.

Single refill kit for the Hill Dry-Pac Pro Air Dryer Filter.We recommend changing your Dry-Pac Pro filters and media every 10 hours of usage or 3 months, whichever comes first.The kit has everything you need to refill your Dry-Pac Pro for one full refill and includes:1 x Sachet of Dry-Pac Media6 x Carbon Filters1 x Micro Fibre Filter

Revolutionary Eazy filling system - Filling your PCP has now become much easier thanks to Edgun: The filling process has now become much faster and less air is wasted! This revolutionary design does not work exclusively with Edgun air rifles. The most important points: No wasted air Super Silent (no need to vent the hose) Super fast No need to regulate the flow with the tank valve Universal (usable with every air pressure weapon brand) Lightweight Made from high -quality materials1x foster female connection1x bottle plug50cm hose

The Next evolution has arrived...The EC300 evoOur latest compressor is literally the evolution of 182 years of Engineering Research and Development by Ernest Hill Ltd.Designed, Manufactured and Assembled by Hill Pumps in our Sheffield, UK, Factory.The evo has a number of changes and improvements in how the compressor works, including some great new features, making the Hill Compressor even more reliable, durable and with a better user experience.We have built in an Automatic Air Pressure PurgeThis kicks in whenever the motor on the compressor stops, so when it goes into a cooling cycle and when a fill is paused or finished.This not only takes the strain off the motor when starting again against very high pressures, but has the added benefit of purging the air, including any moisture from inside the unit.This is very important for people filling larger rifles and or cylinders.The new unit also benefits from our continuous improvement in R & D, including our new super durable Shuttle Valve, which we made from some quite exotic material….Users should note that this shuttle valve does give the compressors a unique sound compared to other compressors out there on the market, but they are very efficient, extremely long lasting and when you hear that sound you will now instantly that it is a Hill Compressor!We have built in a new highly accurate digital pressure sensor with an additional analogue gauge, this is extremely accurate, but also means that you no longer need to recalibrate the compressor during a major service.The evo can be set as low as 50 bar (755 psi) and up to 310 bar (4500 psi).The evo also benefits from completely new electronic architecture along with completely new software, as with all Hill products the electronics have been designed and tested in house by our own software, and electronics engineers, and believe it or not the PCB's are manufactured here in Sheffield too.This new evo is incredibly simple to service and maintain, with tutorial videos available on our YouTube Channel (search Hill Pumps) along with our amazing team of customer support staff based in our Sheffield office.All this has also been achieved whilst keeping The evo at the same RRP as the EC-3000, a true feat of engineering!The EC-3000 evo is available to order online and at all good gun shops throughout the U.K.If you are looking for the ultimate in moisture protection for your gun and compressor you can add The Hill Dry-Pac Pro which is fully compatible with both the EC-3000 evo and the original EC-3000 models.For Trade Sales in your local market please contact us for information: sales@hillpumps.comDownload The Latest Version of The EC-3000 evo User Instruction Manual HereBoth our crank and silicone oils have been specifically manufactured and designed for use with the EC-3000 and EC-3000 evo Electric Compressors. No other oils should be used with the EC-3000 or EC-3000 evo.The Crank Case Oil (Red) is in the perfect size bottle for the unit as it takes almost the whole bottle to fill the crank properly on the initial fill, and should not need topping up for some time. When filling the crank oil please ensure that it is filled properly, this should require near enough the whole 50ml bottle.The Silicone Oil (Clear) is used all the time by the pump and should need replacing after approximately 50 hours of run time, this is also the correct point to change the Crank Oil.

EDgun pEaZy Fill Adapter Foster Quickfill ConnectionProbably the easiest way to fill your PCP gun!Attached right to the bottleCompact, saves spacePerfect while out and about

8309 Hand pump MK5 with 1/8 "BSP connection and dry filter The 5th generation of the Hill PCP pump! The usual exterior with a whole new inner life ... Our most smooth pump so far - approximately 20% easier to use for an average person Higher pressure - the MK5 pump reaches 300 bar / 4500 PSI Quick Service - faster and easier to use than your predecessors Including hose with Quickfill 1/8 "BSP connection.

8301 Hill hand pump MK5 with dry air unit The 5th generation of the Hill hand pump to easily fill the compressed air cartridges of rifles or pistols Lower effort compared to the MK 4 hand pump Larger pumping performance with 0.231 liters per hub Withdraws up to 90% of the humidity using the patented Hill dry air filter

Combines our Dry-Pac Technology with Carbon Filters for the ultimate in moisture protection for your gun or cylinder.Designed for use with the Hill EC-3000 Electric Air Compressor Pump.Provides ultra clean and dry air even in the most humid conditions and environments.Pressure rating of up to 4500 psi / 310 Bar.Has 4 stages of Filtration:Stage 1: PMV Regulated Condensation.Stage 2: Activated Carbon FiltersStage 3: Absorption Desiccant Media.Stage 4: Micro Fibre.Easy & Affordable - The Hill Dry-Pac Pro has been designed with ease of use and affordability at the heart of what it does. It is easy to refill (see our YouTube guide below) and just as affordable as well.High Quality - The Hill Dry-Pac Pro uses high quality corrosion resistant materials.Compatible - The Dry-Pac Pro is compatible with most standard hose connections and fittings using the supplied hose with 1/8" BSP connection.Made in the UK - The Hill Dry-Pac Pro has been designed and manufactured alongside the Hill EC-3000 Electric Compressors in our Sheffield, UK, factory.What's in the box:1 x Dry-Pac Pro Air Dryer Tube.1 x High Pressure HoseDedicated Mounting Kit for the Hill EC-3000 Electric Air Compressor Pump.2 x Filter Refill Kits & Everything you need to get started.We recommend changing your Dry-Pac Pro filters and media every 10 hours of usage or 3 months, whichever comes first.